Reply To: help with settings and discs

HomeForumsGeneral Discussionhelp with settings and discsReply To: help with settings and discs

Author Replies
twisted247 # Posted on 2012-12-07 at 10:33AM UTC

imageburn settings

BurnProof – Enabled
Forced Hyper Tuning – ON
Online Hyper Tuning – ON
Smart Burn – ON
OverSpeed – Disabled
Buffer – 80mb
Burn Speed – 4x or 2×4

TO FULLY BURN XGD3 ON A 15-CENT-PRICED DISC (very common RICOHJPN-D01-67 media, any brand is possible)

First of all, we must get a Lite-On iHASx24 DVD burner (or their clones such as ASUS DRW-24B3ST and so on) and flash iXtreme Burner Max firmware.

After flash, run ImgBurn

0.As in iXtreme Burner Max official tutorial, turn on Tools -> Settings -> Write -> Perform OPC Before Write, because RICOHJPN-D01-67 media is forced to perform write at least 4xs
1.Select “Write image file to disc” as usual.

2.Click “Advanced Settings” button in bottom right corner. (Marked red in screenshot)

3.Open Lite-On panel in Advanced Settings. It is required to click the individual “Change” button if you changed any setting item and a “Success” message will pop up to confirm the change.

- Turn on Online HyperTuning

- Turn on SmartBurn

- Turn off OverSpeed

- Optionally turn on or off Force HyperTuning according to your disc quality

Now you are ready to go! Enjoy XGD3 backups dear friends

Note that in our tests, some discs won’t work at all even with all settings done!! Please try and buy another brand of disc if you encounter this.

!!Way Two!!

This will fix it!!!! patch your games with this link all individual topology patches!!

then flash your ihas with this edited c4evas fw iHAS-124B-AL0S-MKM001MKM003-final_AONE+RITEK+MKM003x2speed.bin then restart your pc or laptop, this is for ihas 124b.


Open IMGBurn and go to TOOLS>SETTINGS>WRITE. Clear the box that Performs OPC Before Write. Then go to TOOLS>SETTINGS>I/O and click Page 2 tab. Move buffer size between 71-73mb, Main Buffer Threshold to 25%, and Device to 50%. Press Ok
Prepare to burn (Write Image File To Disc). On this page you can change the setting to burn at 2.4x and advanced settings (settings area bottom-right of the three icons in that area). Go to Lite-On tab…In the Change For: dropdown-list you will disable Forced HyperTuning, Online HyperTuning, and OverSpeed. If not enabled, Enable SmartBurn. Press OK.
Burn your XGD3 and verify. It should verify at 100%.

all the edited fw does is lets aone and ritek disks burn at 2.4 speed, this will not **** your drive up. all dvd burners can burn at 2.4 speed, its just as good as c4s fw!

this will work for everyone,