Reply To: Stupid open tray error wont go away

HomeForumsGeneral DiscussionStupid open tray error wont go awayReply To: Stupid open tray error wont go away

Author Replies
Angry_Lemur # Posted on 2012-04-15 at 08:07AM UTC
avatar

Hey buddy, did you desolder the bridged points on the laser? The blob of solder is located to the left of the ribbon cable plug on the laser if you are looking at the plug with the screw to the bottom (this is assuming your laser is for a LiteOn drive. Another common problem with the LiteOn drive is that the laser can get stuck at the back of the drive, push your laser to the front before testing it.

http://www.mod-xpress.com