Reply To: XGD3 testing with KProbe2

HomeForumsGeneral DiscussionXGD3 testing with KProbe2Reply To: XGD3 testing with KProbe2

Author Replies
phrizz # Posted on 2011-11-07 at 10:34PM UTC
avatar

Anyway, here are my first burn settings and test results on Verb MKM001 (MIS)..

1st Burn
EEPROM settings:
Smartburn = ON
Force Hyper Tuning = ON
Online Hyper Tuning = ON
Over Speed Writing = OFF

ImgBurn settings:
OPC = ON
Burn Speed = 2.4x

KProbe2 results (ASPI):
PI Max = 263
Pi Avg. = 41.76
Pi Total = 1309147

PIF Max = 5
PIF Avg. = 0.11
PIF Total = 3500

KProbe2 results (SPTI):
PI Max = 263
Pi Avg. = 42.45
Pi Total = 1330730

PIF Max = 5
PIF Avg. = 0.11
PIF Total = 3482

My first burn went smooth, and the test results for ASPI driver were looking great until the scan hit between the 40-50% mark, then the Pi started to skyrocket. SPTI driver performed about the same, so overall the first burn was pretty disappointing..not to mention confusing, this sucks. I will post my second burn settings and results when they finish.. =/