power calibration area full message

HomeForumsGeneral Discussionpower calibration area full message

This topic has 3 voices, contains 2 replies, and was last updated by avatar QuickMythril 2243 days ago.

Viewing 3 posts - 1 through 3 (of 3 total)
Author Posts
Author Posts
2011-10-24 at 06:16AM UTC #2779
avatar
w1ngnut

hello all after attempting to burn Batman A.C. with the new firmware i have been getting a constant message stating power calibration area full and also read errors after only 30 seconds this occurs if i burn at 2.4 or 4 speed any help or advice would be greatly welcomed

2011-10-24 at 09:36AM UTC #2781
avatar
whompus60

That’s normally from using bad media. What disk’s are you using?

2011-10-25 at 04:22PM UTC #2889
avatar
QuickMythril

when you burned at 2.4 speed, did it say “write speed miscompare: wanted 2.4x, got 4x”? if so then your discs don’t support burning at that speed. you can change the firmware to force it though. some people have had success burning at slower speeds.

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.